Leon Mk2
| Pedal gear, brake pedal: general assembly diagram |
Warning
|
Note!| Before fitting, grease all support points with grease part nº -G 000 602-. |
| 1 - | Support block |
| 2 - | Hexagonal bolt |
| q | 25 Nm |
| 3 - | Brake pedal switch -F47- |
| q | For engine control unit |
| q | Checking or adjusting → Injection and Ignition System; Rep. Gr.24 |
| 4 - | Nut, self-locking |
| q | 25 Nm |
| q | 5 units, to secure support block to servo brake |
| 5 - | Brake light switch |
| q | Removing and installing → Running gear; self-diagnosis for ABS; Rep. Gr.01 |
| q | Before fitting the brake light switch, the brake pedal should be engaged with the servo brake pressure-bar |
| 6 - | Safety |
| q | Make sure it is properly seated |
| 7 - | Bush bolt for brake and clutch pedal |
| q | Assembly position: the recess -arrow- is to be found on th clutch pedal side |
| 8 - | Brake pedal |
| 9 - | Bush socket |
| q | To support the enveloping tube |
| 10 - | Cap |
| 11 - | Clutch pedal |
| q | Removing and installing → 5-speed manual gearbox; Rep. Gr.30 |
| 12 - | Safety |
| q | Make sure it is properly seated |
| 13 - | Hexagon nut |
| q | 25 Nm |
| 14 - | Support |
