Leon Mk2
Rear brake - general assembly diagram |
1 - | 4 Nm |
2 - | Brake disc |
q | Thickness: 9 mm |
q | Wear limit: 7 mm |
q | If worn, always replace by axles |
3 - | Protective cap |
q | Always replace. |
q | Removing and fitting → Running gear, axles, steering; Rep. Gr.42 |
4 - | 70 Nm + 30° |
q | Replace after each removal |
5 - | Wheel hub and bearing assembly |
q | For vehicles fitted with ABS, the sensor ring is fitted in the wheel hub. |
q | Replace entire unit |
q | Removing and fitting → Running gear, axles, steering; Rep. Gr.42 |
q | Allocation → Spare parts catalogue |
6 - | 30 Nm + 90° |
q | Replace after each removal |
7 - | Cover plate |
8 - | Axle connection |
9 - | ABS rev. sensor |
q | Before fitting the sensor, clean the inner surface of the hole and apply solid lubricant paste → Parts catalogue. |
10 - | 8 Nm |
11 - | Axle body |
12 - | Hand brake cable |
q | Adjusting handbrake → Chapter |
13 - | 30 Nm + 30° |
14 - | Hoses and brake pipe |
q | With hollow bolt and sealing washers |
q | Do not dismantle, replace complete |
q | Tightening moment of the hollow screw 35 Nm |
q | Do not unscrew to change the brake pads |
15 - | 35 Nm |
q | Replace |
16 - | Brake calliper |
q | removing and fitting → Chapter. |
17 - | Brake pads |
q | Do not unscrew hose when replacing brake pads |
q | Always replace by axles |
q | removing and fitting → Chapter. |
q | Thickness: 16.9 mm, including mounting plate |
q | Wear limit: 2.0 mm without mounting plate |
q | Check the thickness → Booklet |
18 - | Brake pad retaining springs |
q | Always replace when brake pads are replaced |
19 - | Brake back plate with guide pins and protective cover |
q | These are delivered as a spare part unit and are sufficiently lubricated in the guide pins |
q | If the protective covers or the guide pins have been damaged, fit the whole repair unit. Use the attached grease to lubricate the guide pins |