Leon Mk2
|
| 1 - | Speed sensor |
| q | Removing and installing → Chapter |
| q | Before fitting the speed sender, clean the inner surface of the hole and apply solid lubricant paste → Spare parts catalogue |
| 2 - | Hexagon socket head bolt |
| q | Specified torque: 8 Nm. |
| 3 - | Bolt |
| q | Tightening torque: 90 Nm + 90° |
| q | Replace after each removal |
| 4 - | Wheel bearing housing |
| 5 - | Splash plate |
| 6 - | Torx bolt |
| q | Specified torque: 12 Nm. |
| 7 - | Wheel hub with wheel bearing |
| 8 - | Brake disc |
| q | Allocation, measurements, wear limits → Anchor |
| q | Do not separate the brake disks from the wheel hubs by force. If necessary, use an oxide solvent; otherwise the brake disks may be damaged. |
| q | To remove, extract the brake calliper, along with the hollow bolt, the hose and the ring tube. |
| q | Always replace by axles |
| 9 - | Cross-head screw |
| q | Specified torque: 4 Nm. |
| 10 - | Bolt |
| q | Only with front wheel drive |
| 11 - | Brake pads |
| q | Brake pad thickness, wear limit → Anchor |
| q | Check the thickness of the pads: → Booklet1 |
| q | Removing and installing → Chapter |
| q | Always replace by axles |
| 12 - | Brake carrier |
| q | With guide pin and protection hood |
| q | Delivered as assembled part, with sufficient grease on the guide pins |
| q | In case of damage to the protection hoods, fit the repair kit → Parts catalogue, use the grease pad supplied to grease the guide pins |
| 13 - | Brake pad retention springs |
| q | Always renew when changing pads. |
| 14 - | Housing for brake calliper |
| q | Do not unscrew the brake line when replacing brake pads |
| q | Piston diameter → Anchor |
| q | Removing and installing → Chapter |
| q | Repairs → Chapter |
| q | Following repairs or a replacement, first adjust the hand brake cable → Chapter |
| 15 - | Flexible tube clip |
| 16 - | Brake line |
| q | Specified torque: 14 Nm. |
| 17 - | Bolt |
| q | Specified torque: 35 Nm. |
| q | Self-locking |
| q | When loosening and tightening, lock the guide pin |
| q | Replace after each removal |
| 18 - | Hand brake cable |
| q | Removing and installing → Chapter |
| q | Adjusting handbrake → Chapter |
| 19 - | Elastic hook |
| 20 - | Brake hose |
| q | Specified torque: 38 Nm. |
