seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Brake master cylinder with brake servo: Removing and installing > < Ball head: Adjustment for RL vehicles

Leon Mk2

Brake fluid reservoir: Dismantling and assembly
Brake fluid reservoir: Dismantling and assembly
Removal:
  Note
t  Lay out sufficient number of lint-free cloths in the area of the plenum chamber.
t  Evacuate as much brake fluid as possible from brake fluid reservoir using evacuation bottle.
–  Drain the fluid from the reservoir.
   
–  Disconnect connector on sensor for brake fluid reservoir -1-.
–  Pull off vacuum hose -2-.
  A47-0139
–  Unscrew mounting bolt -1- from brake fluid reservoir.
  Note
t  Protect the plenum chamber against any brake fluid which escapes.
t  The brake fluid reservoir is arrested at the bottom of the master brake cylinder.
–  To remove reservoir, press down locking lug and at the same time pull brake fluid reservoir out of sealing plugs.
–  Remove brake fluid reservoir.
Installation
Installation is carried out in the reverse sequence; note the following:
t  Before installing brake master cylinder, clean any residual brake fluid off plenum chamber.
–  Bleed brake system → Chapter.
  A47-0140

Brake master cylinder with brake servo: Removing and installing > < Ball head: Adjustment for RL vehicles