Leon Mk2
Assembly overview - brake caliper C 60 |
t | When carrying out repairs, install all parts supplied in repair kit. |
t | Use only methylated spirits to clean the brake caliper |
t | Apply thin coat of assembly paste G 052 150 A2 to brake cylinders, pistons and seals. |
1 - | Grease cap |
q | Fit onto bleeder valve |
2 - | Bleeder valve, 13 Nm |
q | Apply thin coat of assembly paste G 052 150 A2 to thread before screwing in. |
3 - | Hexagon bolt, 35 Nm |
q | Always renew if removed |
4 - | Guide pin |
5 - | Protective cap |
q | Insert into brake carrier and guide pin groove; grease groove beforehand, use repair kit grease pack. |
6 - | Brake back plate |
q | Supplied as replacement part, assembled with guide pin and protective caps, and with sufficient grease on guide pins. |
q | If the protective covers or the guide pins have been damaged, fit the whole repair unit. Use grease sachet supplied to lubricate the guide pins. |
7 - | Protective cap |
q | removing and fitting → Chapter |
q | Take care not to damage when inserting piston. |
8 - | Piston |
q | removing and fitting → Chapter |
q | Apply thin coat of assembly paste G 052 150 A2 to piston before inserting. |
9 - | Seal |
q | removing and fitting → Chapter |
10 - | Brake caliper |