SEAT Workshop Service and Repair Manuals > Leon Mk2 > Running gear | Brake systems | Brake, brake mechanics | Removing, installing and adjusting brake light switch | New version of brake light switch (round)

Installing and adjusting:

To ensure secure installation, install brake light switch only once.

–	Before installing pull plunger out fully.

–	Guide switch through assembly hole, press against pedal and secure by turning 45° to right.

–	Brake pedal must remain at rest position (not depressed).

–	Fit brake light switch connector.

–	Check function of brake light.

After adjusting the brake light switch check whether the brake pedal is on the limit stop (rest position).

–	Install driver's side trim → General body repairs, interior; Rep. Gr.70

SEAT Workshop Service and Repair Manuals