Leon Mk2
Note!
|
1 - | Allen bolt, 10 Nm |
2 - | Brake disc |
q | Brake disc thickness: 25 mm. |
q | Internally ventilated brake disc: Ø 288 mm. |
q | Wear limit: 21 mm. |
q | When worn, always renew on both sides of axle. |
q | Never remove brake discs from hub by force. If necessary use penetrating fluid, because otherwise brake discs can be damaged. |
3 - | Hexagon bolt |
4 - | Cover plate |
5 - | Allen bolt, 10 Nm |
6 - | ABS speed sensor |
q | Before inserting sensor, clean fitting hole inner surface and coat with lubricating paste G 000 650 |
7 - | Hexagon bolt, 10 Nm |
8 - | Wheel bearing housing |
9 - | Drive shaft |
q | With rotor for speed sensor |
10 - | Brake hose, 14 Nm |
11 - | Cover cap |
12 - | Guide pin, 30 Nm |
13 - | Bush |
14 - | Brake caliper |
q | Removing: |
q | Do not disconnect brake hose when changing brake pads. |
q | Remove brake pads → Chapter. |
q | Insert brake pedal actuator -V.A.G 1869/2- (and relieve pressure). |
q | Unscrew brake hose → Item from brake caliper |
q | Installing: |
q | Insralling brake pads → Chapter. |
q | Connect brake hose to brake caliper. |
q | Remove brake pedal actuator -V.A.G 1869/2-. |
q | Repairing → Chapter. |
15 - | Retaining spring |
q | Insert in both brake caliper housing holes |
16 - | Brake carrier |
q | Supplied as replacement part, assembled with sufficient grease on guide pins. |
q | If protective caps are damaged, use repair kit |
q | Use grease sachet supplied to lubricate guide pins. |
17 - | Hexagon bolt, 200 Nm |
q | M14 x 1.5 x 38 |
18 - | Brake pads |
q | Thickness 14 mm not including backplate. |
q | Brake pad with retaining spring is seated on piston |
q | Brake pad with adhesive film on backplate is seated on outer side |
q | Wear limit: 2 mm not including backplate. |
q | Checking thickness → Booklet10.1. |
q | Always renew both sides. |
q | Removing and installing → Chapter. |