seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Assembling > < Dismantling and assembling drive shaft with constant velocity joint

Leon Mk2

Dismantling
Dismantling
   
Removing outer constant velocity joint
–  Separate the dustguard of the constant velocity joint with a punch.
–  Fit the extractor -T20181- on the neck of the articulated half-shaft and screw the bolt on the constant velocity joint until it is released.
  E40-10001
Driving off cover from inner joint
–  Remove circlip.
–  Remove both clamps and slide boot towards outer joint.
  N40-0448
Pressing off inner constant velocity joint
  N40-0481

Assembling > < Dismantling and assembling drive shaft with constant velocity joint