| –
| Screw a new self locking nut onto the ball joint → Item, immobilizing with the allen key (5) |
| 1 - | Allen key (5), shortened approximately 10 mm. |
| 2 - | Gear fork spanner -SAT 8010/18A- |
| 3 - | Torque wrench -SAT 8010- |
| –
| Bolt the ball joint of the swinging arm with the hexagonal bolts → Item (bolts over the previous marks). |
Note | Ensure that the dustcover is correctly fitted without twisting or damaging it. |
| –
| Replace the dodecagonal nut of the half-shaft and tighten it → Chapter. |
|
|
|
