seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Subframe, stabiliser bar, traverse swinging arm > < Sender for vehicle level for vehicles with automatic light width control Assembly overview

Leon Mk2

Sender for vehicle level for vehicles with automatic light width control Removing and installing
Sender for vehicle level for vehicles with automatic light width control Removing and installing
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1332-, see equivalent → Anchor.
  W00-0428
t  Torque wrench -V.A.G 1410-, see equivalent → Anchor.
removing and fitting
Retaining clip for coupling rod of vehicle level sender -G78 - must be released when removing and installing track control link.
  Note
When attaching coupling rod to crank arm of vehicle level sender -G78-, use 10 mm open-ended wrench (with dimension -A- = 4 mm) to avoid damaging seal.
  W00-0554
–  Dimension - A - 4 mm
–  Mount the wheels and the tighten the wheel bolts → Running gear, axles, steering; Rep. gr. 44
–  Use pliers to attach retaining clip for coupling rod from vehicle level sender -G78- to track control link between stops.
Ensure at the time of assembly of the light width control, that the crank is in the correct position to the coupling rod.
  Note
t  The coupling rod must be inclined and point to the front and below.
t  Crank must face towards the rear.
  A40-0221

Subframe, stabiliser bar, traverse swinging arm > < Sender for vehicle level for vehicles with automatic light width control Assembly overview