SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Wheel bearing housing, trailing link (four-wheel drive, subframe made from aluminium and wheel bearing housing made from cast st >
< Renewing bonded rubber bushes in subframe: replace
Leon Mk2
Running gear
Running gear, axles, steering
Rear suspension, drive shaft
Anti-roll bar
Coupling rod for Stabilizer bar: Removing and installing
Coupling rod for Stabilizer bar: Removing and installing
Coupling rod for Stabilizer bar: Removing and installing
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Torque wrench -V.A.G 1331-, see equivalent
→ Anchor
.
Removal:
–
Remove wheel.
–
Remove underbody paneling
→ Body - outer assembly work; Rep. gr. 66
.
Vehicles with heavy-duty suspension
–
Remove stone impact protection from trapezoidal link
→ Item
.
Continued for all vehicles
–
Unscrew mounting bolts
-1-
on stabiliser rod on trapezoidal link.
–
Unscrew mounting bolt
-2-
on stabiliser rod. The counterhold joint with an open-end spanner.
–
Take out coupling rod.
Installation
Installation is carried out in the reverse sequence; note the following:
Tightening torques
→ Chapter
Running gear
Running gear, axles, steering
Rear suspension, drive shaft
Anti-roll bar
Coupling rod for Stabilizer bar: Removing and installing
Wheel bearing housing, trailing link (four-wheel drive, subframe made from aluminium and wheel bearing housing made from cast st >
< Renewing bonded rubber bushes in subframe: replace