Leon Mk2
-Arrow- indicates direction of travel. |
1 - | Eccentric bolt |
q | After slackening off, perform wheel alignment → Chapter |
q | Do not turn more than 90° to the left or to the right (that is, from the permitted minimum adjustment range to the maximum) |
2 - | Nut |
q | M12 x 1.5 |
q | 95 Nm |
q | Self-locking |
q | Replace after each removal |
q | Always tighten bolted joints with suspension in unladen position → Chapter |
3 - | Eccentric washer |
q | Inner hole with lug |
4 - | Eccentric bolt |
q | After slackening off, perform wheel alignment → Chapter |
q | Do not turn more than 90° to the left or to the right (that is, from the permitted minimum adjustment range to the maximum) |
5 - | Eccentric washer |
q | Inner hole with lug |
6 - | Nut |
q | M12 x 1.5 |
q | 80 Nm |
q | Self-locking |
q | Replace after each removal |
q | Always tighten bolted joints with suspension in unladen position → Chapter |
7 - | Sub-frame |
8 - | Bolt. |
q | M12 x 1.5 x 125 |
q | 90 Nm + 90° |
q | Replace after each removal |
9 - | Lower transverse arm |
q | removing and installing → Chapter |
10 - | Nut |
q | M12 x 1.5 |
q | 90 Nm + 90° |
q | Self-locking |
q | Replace after each removal |
q | Always tighten bolted joints with suspension in unladen position → Chapter |
11 - | Bolt. |
q | Replace after each removal |
12 - | Threaded rivet |
q | M6 |
13 - | Expanding rivet |
14 - | Stone deflector |
15 - | Bolt. |
q | 8 Nm |
16 - | Nut |
q | M14 x 1.5 |
q | 130 Nm + 90° |
q | Self-locking |
q | Replace after each removal |
q | Always tighten bolted joints with suspension in unladen position → Chapter |
17 - | Bolt. |
q | Replace after each removal |
q | Always tighten bolted joints with suspension in unladen position → Chapter |
18 - | Lower transverse swinging arm |
q | removing and installing → Chapter |
19 - | Washer |
20 - | Nut |
q | M14 x 1.5 |
q | 130 Nm + 90° |
q | Self-locking |
q | Replace after each removal |
21 - | Wheel bearing housing |
q | removing and installing → Chapter |
22 - | Washer |
23 - | Bolt. |
q | Replace after each removal |
q | Always tighten bolted joints with suspension in unladen position → Chapter |
24 - | Track rod |
q | Closed in the direction of travel |
25 - | Bolt. |
q | Replace after each removal |
q | Always tighten bolted joints with suspension in unladen position → Chapter |
26 - | Nut |
q | M12 x 1.5 |
q | 90 Nm + 90° |
q | Self-locking |
q | Replace after each removal |