SEAT Workshop Service and Repair Manuals

Removing

–  Open cover -1-. –  Unscrew the star bolts -2-. –  Pull back the cover for the hand brake lever.

–  Remove the hand brake cables from the brake lever -arrows-. –  Remove wheels.

–  Remove the hand brake cable attachment clamp -arrow 1-. –  Extract the handbrake cables from the gain. –  Place the engine and gearbox elevator -SAT 1001 A-.

–  Remove the revolution sensor -arrow 1- and release it from the attachment -arrow 2- (vehicles with ABS). –  Unscrew the shock absorber -arrow 3- from the rear axle.

–  Release the attachment clips -1-. –  Separate the brake lines -2- with the tool -A-56126-. –  Release the ABS sensor cables -3- (if fitted). For vehicles without ABS:

–  Remove the nut and bolt -arrow- securing the braking force regulator spring to the axle. Mark the assembly position.

–  Remove the hand brake cables from the brackets -arrow A- . –  Unscrew the attachment nuts -arrows- from the spring flanges.

–  Lower the rear axle using the engine and gearbox elevator -SAT 1001 A-. –  If necessary, use a lever on the central spring bolt to remove it from the rear axle -arrows- .