Unscrew nut -1- and pull out bolt (shown without splash plate)
–
Unscrew bolts -2-.
Note
Wheel housing liner does not have to be removed.
–
Remove shock absorber.
Installation
Installation is carried out in the reverse sequence; note the following:
Note
t
Replace bolts and self-locking nuts ⇒ instructions in the exploded view from page → Chapter.
t
Bonded rubber bushes can only be turned to a limited extent. The mountings of the suspension links must therefore only be tightened when the suspension is in the unladen position → Chapter.
–
Tighten upper mounting bolts -2- on shock absorber to specified tightening torque → Item.