Leon Mk2
| Assembly overview: electromechanical steering box, LHD vehicle |
| 1 - | Crossmember |
| 2 - | Bolt. |
| q | 30 Nm |
| q | Always renew if removed |
| 3 - | Power steering box |
| q | With power steering control unit -J500- |
| q | With electromechanical power steering motor -V187- |
| q | With steering moment sender -G269- |
| q | Can be tested in guided fault finding using → Vehicle diagnostic tester |
| q | removing and installing → Chapter |
Note| Any entries in the event memory must be deleted before renewing the steering box → Vehicle diagnostic tester. |
| 4 - | Wheel bearing housing |
| 5 - | Nut |
| q | Tighten to 100 Nm, then loosen (turn back) 180° and retighten to 100 Nm |
| q | Self-locking |
| q | Always renew if removed |
| 6 - | Sub-frame |
| 7 - | Bolt. |
| q | 50 Nm and then turn 90° further |
| q | Always renew if removed |
| 8 - | Heat shield |
| 9 - | Torx screw |
| q | 6 Nm |
| q | Self-tapping |
| 10 - | Electrical wire |
