Mark the assembly position of the cover -2- in relation with the steering casing -arrow-.
–
Remove the cover -2- by unscrewing the bolts -3-.
Avoid making contact with the electrical components -arrow-.
–
Observe the general repair instructions → Chapter.
Caution
If work is interrupted for extended periods of time, the open casing of the steering box must be covered with a sheet of plastic to protect it from moisture.
–
mark the route of the sender cable in the steering casing.
–
Release the sender cable in the steering housing.
Note
The sender cable of the steering casing has a lock -arrow- for the spiral spring of the steering pinion. When removing the sensor cable, make sure the spiral spring is bent only sufficiently to remove the connector (at most, bend 30º).
–
Separate the connector of the sender cable from the steering pinion.
Lever the contact with a screwdriver (3 mm) to remove it from the spiral spring's casing, in the -direction of the arrow-, as shown in the diagram.
–
Remove the block of the steering casing in the -direction of the arrow-.
–
Release the sender cable carefully from the steering casing.
–
Disconnect the sender cable connector on the power steering control unit - J500 -.
–
Press the button -A- in the -direction of the arrow- to extract the connector.