Leon Mk2
| Power steering box TWR brand: dismantling and assembling |
| 1 - | Right hand side link bar head |
| q | removing and fitting → Chapter |
| 2 - | 50 Nm |
| 3 - | Spring-type hose clip |
| q | Remove and fit with the pliers -T20029- |
| 4 - | Dustguard |
| q | Can only be replaced with the steering box removed |
| q | Before proceeding with the removal of the dustguard, the steering bar head -1- must be removed |
| q | Fitting → Anchor |
| 5 - | Securing clip |
| q | replacing |
| q | Open with pliers |
| q | Fitting → Anchor |
| 6 - | Seal |
| 7 - | 6 Nm |
| q | For securing the thermal protection plate → Item |
| 8 - | Heat shield |
| q | Only for vehicles with the exhaust tube above the subframe |
| 9 - | Link bar, 80 Nm |
| q | removing and fitting → Chapter |
| 10 - | Clip |
| q | Replace in case of damage to the thread of the impression nut |
| 11 - | Rubber |
| q | Observe the position when fitting: The groove must be aligned to the rear. |
| q | Replace if damaged or worn |
| 12 - | Power steering box |
| q | No repair work can be done |
| q | removing and fitting → Chapter |
| q | Checking the centring → Chapter |
| q | Adjust convergence → Chapter |
| 13 - | Seal |
| q | replacing |
| 14 - | Power steering sensor -G250- |
| q | Power steering sensor → Chapter |
| 15 - | 5 Nm |
| 16 - | Left hand side link bar head |
| q | removing and fitting → Chapter |
