Fitting in left-hand drive and right-hand drive vehicles up to identification number 7M SP 020861 |
–
| Push the steering column inwards as far as possible. |
–
| Hook the column to the cross member and the pedal support block at the same time. |
–
| Tighten the rupture bolts until the heads break off. |
–
| Tighten the bolt of the steering column/pedal support block, and apply the specified torque → Chapter. |
–
| Place the steering driveshaft onto the steering pinion, and fold down the hinge. |
–
| Tighten the bolt of the steering driveshaft, and apply the specified torque → Chapter. |
–
| Position the steering column combination switch onto the steering lock body, and tighten the bolt. |
–
| Connect the steering lock body connector. |
–
| Position the upper lining of the lock body, and tighten it. |
–
| Position the lower lining of the lock body, and tighten it. |
–
| Fit the steering wheel, and fasten it with a new bolt. |
–
| Fit the left-hand side lining situated below the instrument panel. |
|
|
|