seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fitting in left-hand drive and right-hand drive vehicles up to identification number 7M SP 020861 > < Steering mount and steering column: removing and fitting

Leon Mk2

Removing
Removing
–  Remove the airbag unit (only in vehicles with airbag → Chapter).
–  Remove the steering wheel (steering wheel with airbag → Chapter).
–  Remove the lower covering for the steering column combination switch.
   
–  Remove the upper covering for the steering column combination switch -arrows-.
–  Remove the left-hand side lining situated below the instrument panel.
–  Unplug the connector of the steering lock body.
  N48-0170
–  Loosen the bolt of the body of the steering lock -arrow-.
–  Remove the steering column combination switch.
  N48-0171
–  Loosen the bolt of the steering driveshaft -arrow-.
–  Lift the hinge -1-.
  N40-0098
–  Loosen the lower bolt of the steering column/pedal support block.
1 - Floor carpet
2 - Hexagonal bolt
3 - Hinge
  WARNING
Use safety goggles.
  N70-0154
–  Drill out the rupture bolts -1- or use a chisel, if necessary.
–  Pull the steering column upwards and remove it.
–  If necessary, remove the drilled bolts from their support (the second bolt is not shown for clarity).
  N48-0172

Fitting in left-hand drive and right-hand drive vehicles up to identification number 7M SP 020861 > < Steering mount and steering column: removing and fitting