Leon Mk2
Note
|
1 - | Poly-V belt pulley |
q | When fitting the vane pump pulley, check that it is aligned with the crankshaft pulley |
2 - | Allen screw, 25 Nm |
q | Immobilize with the -V.A.G 1590- to loosen and tighten |
3 - | Poly-V belt |
q | Allocation → Electronic parts catalogue“ETKA” |
q | Tighten → Chapter |
4 - | Pressure piping |
5 - | Seals |
6 - | Hollow screw, 40 Nm |
7 - | Hose clamp |
8 - | Suction hose |
9 - | Vane pump |
q | Before fitting it, fill with oil ⇒ note on page → Chapter |
q | Fitting → Chapter |
10 - | Hexagonal bolt M8 x 32, 25 Nm |
11 - | Hexagonal bolt M8 x 85, 25 Nm |
12 - | Hexagonal bolt M8 x 50, 25 Nm |
13 - | Hexagonal bolt M8 x 50, 25 Nm |
14 - | Support |
q | Check that it is fastened without tension → Chapter Fitting the vane pump |
15 - | Centroid clamp |
q | Check that it is fastened without tension → Chapter Fitting the vane pump |
16 - | Hexagonal bolt M10 x 98, 45 Nm |
17 - | Hexagonal bolt M8 x 42, 25 Nm |
18 - | Bolt, 25 Nm |
q | Not fitted in vehicles with diesel engines |
19 - | Adjusting bolt, 25 Nm |
q | Tighten, → Chapter |
20 - | Tensor clamp |
21 - | Hexagonal nut, 25 Nm |
22 - | Hexagonal bolt, 25 Nm |
23 - | Hexagonal nut, 25 Nm |
24 - | Console |