| Front camera for driver assistance systems -R242- |
Note | The following situations can cause the camera function to be impaired by sustained poor visibility of the lane marker lines: |
| t
| Camera vision is obstructed by dirt or ice, etc. This should be rectified accordingly. |
| t
| The field of view of the camera is fogged over. |
| The camera aperture must be cleaned manually if there is heavy contamination on the inside of the windscreen in the field of view of the camera. To do this, the control unit and lens hood must be removed and the windscreen cleaned using cleaning solution. Removing the control unit and lens cover → Rep. gr.94. |
| Correct calibration is a basic precondition for the driver assistance system's Front camera for driver assistance systems -R242-. |
| The following reasons require recalibration of the front camera for driver assistance systems -R242-: |
| t
| „No or incorrect basic setting/adaptation“ entry stored in the event memory. |
| t
| The driver assistance system's front camera -R242- was replaced. |
| t
| Windscreen has been renewed or removed. |
| t
| Rear axle toe setting has been adjusted. |
| t
| Modifications have been made to the car's running gear that have an effect on the body height. |
Note | t
| Before calibrating the front camera for driver assistance systems -R242-, read out event memory and rectify faults as necessary. |
| t
| The geometrical driving axis of the car must be measured in order to calibrate the front camera for driver assistance systems -R242-. It is used as a reference position for the setting device -VAS 6430-. |
| t
| Calibration of the front camera for driver assistance systems -R242- is only permitted using a measuring instrument authorised by SEAT! |
| t
| Calibration of the Front camera for driver assistance systems -R242- is only permitted using the setting device -VAS 6430-! |
|
|
|
