seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Wheel rims and tyres > < Assembly overview - power assisted steering vane pump, vehicles fitted with VR6 engine

Leon Mk2

Removing and installing vane pump for vehicles with VR6 engines
Removing and installing vane pump for vehicles with VR6 engines
Special tools and workshop equipment required
   
t  Water pump wrench -V.A.G 1590-
Removing
–  Remove noise insulation tray.
–  Remove poly V-belt → 6-cylinder injection engine, mechanics; Rep. Gr.13.
–  Remove supply and pressure pipes and drain hydraulic oil.
  W00-0444
–  Remove belt pulley.
  V48-1042
–  Remove bolts -1- and -2-.
–  Remove vane pump from bracket.
Installing
Do not reuse drained hydraulic fluid.
Install in reverse order.
Observe oil level in reservoir, after filling with hydraulic oil and starting engine. The oil level must sink.
If this is not the case, stop engine, unscrew pressure pipe at P.A.S. box and wait until hydraulic oil discharges.
–  Attach pipe again and start engine, top-up oil level.
  V48-1043

Wheel rims and tyres > < Assembly overview - power assisted steering vane pump, vehicles fitted with VR6 engine