seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Adaptation > < Display and evaluation of the values for display group number 005

Leon Mk2

Display and evaluation of the values for display group number 006
   
Display and evaluation of the values for display group number 006
Display group 006
Read measured
value block 6		→Indicated on display  
xxxxxxxxxxxx   
1234Display zonesTarget valueEvaluation
    Vehicle speed right in km/h“0.km/h”See table below
   Impulse transmitter right“Right” 
  Vehicle speed left in km/h“...km/h” 
 Impulse transmitter left“Left” 

   
Display zoneDesignationDisplay contentsFault elimination
1Speed signal from speedometer“Left”
–  Visual check of wiring
–  Check electrical connections of relevant circuit to ensure they are securely and correctly connected, and monitor display at the same time
–  If the display contents do not change upon operation, rectify the fault or renew the relevant component
–  Perform a function test
–  Interrogate the fault memory again
2Speed signal from speedometer in km/h“... km/h”
Speed display depends on how fast the vehicle is currently being driven		 
3Speed signal from speedometer“Right”
 
4Speed signal from speedometer in km/h“... km/h”
Speed display here is permanently “0 km/h”		 

If the displayed values in all display zones are OK:
–  Terminate the function “08 - Read measured value block”.
–  Press the ← key at the bottom left of the tester display twice in succession.
–  Perform the “02 - Interrogate fault memory” function and rectify any faults displayed there.
–  Terminate the diagnostic functions with “06 - End output”.
   

Adaptation > < Display and evaluation of the values for display group number 005