–
| Remove the bulb holder -1- from the lamp. |
–
| Take out the bulb -1- for the rear fog light from the bulb holder -4-. |
–
| Take out the bulb -3- for the reverse light from the bulb holder -4-. |
–
| Separate the plug connector of the LED module -2- from the bulb holder -4- via the resistance of the retaining tab -arrow-. |
Installation is carried out in reverse order, noting the following: |
–
| Fit new bulbs in bulb holder; do not touch the glass part of the bulb with bare hands. |
–
| Switch the plug connector of the LED module. |
–
| Route the wiring harness of the LED module to its fitting position without interruptions. |
|
|
|