seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Vehicles with 1.4 TDI engine ( 51, 55 and 59), manual gearbox > < Vehicles with 1.4 litre fuel injection engine (59 kW), manual gearbox

Leon Mk2

Vehicles with 1.8 litre turbo engine (110 kW), manual gearbox
Vehicles with 1.8 litre turbo engine (110 kW), manual gearbox
Special tools and workshop equipment required
   
t  Torque wrenches -SAT 8010-
Removing:
–  Disconnect battery → Chapter.
  L00-10226
–  Unscrew the securing bolt -arrow- of the turbocharger hose.
  N27-10531
–  Unscrew both securing screws -arrows - and remove the intake manifold pipe upwards.
  N27-10530
–  Release and detach the connection -1- on terminal 50.
–  Remove star head screw -2-.
–  Unscrew the rear securing bolt and remove connector -3- from magnetic switch on terminal 30.
–  Unscrew the nut -5- of the upper bolt on the starter motor.
–  Remove the earth cable -4- and the upper securing bolt of the rear starter motor.
–  Remove the central sound insulation → Body, exterior fitting work; Rep. Gr.50.
  N27-0193
–  Unscrew the nut -1- of the lower bolt on the starter motor -2-.
–  Remove support -3-.
–  Unscrew the securing screws of the starter motor -2- at the bottom and remove the starter motor downwards out of the vehicle.
Fitting:
Installation is carried out in the reverse sequence; note the following:
–  Tighten the fastening bolts or nuts to the torques shown → Chapter .
–  Connect battery → Chapter.
  N27-10212

Vehicles with 1.4 TDI engine ( 51, 55 and 59), manual gearbox > < Vehicles with 1.4 litre fuel injection engine (59 kW), manual gearbox