SEAT Workshop Service and Repair Manuals

Primary locking device with special connector systems Checking sequence   Note If necessary, any housing catches in place (secondary locking mechanisms) must be released or removed prior to disengaging the contacts using the prescribed tool → Chapter.

Faston contact tabs: –  Insert the corresponding release tool into the release duct in the connector housing -arrow-. –  Take hold of the contact on the wire and press it slightly into connector housing.   Note Pressing the contact towards the connector housing causes the retainer tabs of the contact to be lifted off the housing shoulder, enabling them to be released with the release tool.

–  At the same time press the release tool towards the connector housing -arrow- and remove the released contact. –  After the contact has been removed from the connector housing, remove the release tool.

GT 150/280 contacts: –  Insert the corresponding release tool under the release tab in the connector housing. –  Insert the tool by pressing it to the stop -arrow- into the connector housing.

l  The contact is pressed out of the connector housing. –  After the contact has been removed from the connector housing, remove the release tool.

Contacts without tongues –  Insert the release tool under the release tab in the connector housing. –  Push through the release tool with a light upward movement -arrow- onto the limit stop.

l  The contact is pressed out of the connector housing. –  After the contact has been removed from the connector housing, remove the release tool.