Fabia Mk1
Summary of front bonnet components |
1 - | Front bonnet |
q | Removing: |
– | Open front bonnet. |
– | Release screws Pos. 14 and remove bonnet. |
q | Installing: |
Installation is carried out in the reverse order. |
– | adjust → Chapter |
2 - | Radiator grill |
q | Removing: |
– | Open front bonnet. |
– | Release screws Pos. 22 and Pos. 24. |
– | Unclip control lever Pos. 5. |
q | Installing: |
Installation is carried out in the reverse order. |
3 - | Catch hook |
q | Removing: |
– | Open front bonnet. |
– | Release screws Pos. 4. |
– | Remove catch hook with control lever Pos. 5 from the front bonnet. |
q | Installing: |
Installation is carried out in the reverse order. Pay attention to the following: |
– | Replace screws Pos. 4. |
4 - | 9 Nm |
q | self-locking |
q | 3 pieces |
q | replace → Electronic Catalogue of Original Parts |
5 - | Release handle |
q | Removing: |
– | Open front bonnet. |
– | Unscrew nut of Pos. 6 from the stud bolt of the catch hook Pos. 3. |
– | Detach control lever from the catch hook Pos. 3. |
q | Installing: |
Installation is carried out in the reverse order. Pay attention to the following: |
– | Replace nut Pos. 6. |
6 - | 3 Nm |
q | self-locking |
q | replace → Electronic Catalogue of Original Parts |
7 - | Adjusting buffer |
q | The height of the front bonnet Pos. 1 relatively to the wings can be adjusted by unscrewing or tightening the adjusting buffer. |
8 - | Crutch |
9 - | Retaining clip for crutch |
q | clipped into front bonnet Pos. 1 |
10 - | Mounting bracket for crutch |
11 - | Protective rubber covering for crutch |
q | fitted into the mounting bracket Pos. 10 |
12 - | Blind rivets |
q | 4 pieces |
13 - | Bonnet hinge |
14 - | 22 Nm |
q | 4 pieces |
15 - | Cooling-water tank seal |
q | The sealing joint must be positioned in the middle of the wing -arrow- |
16 - | The protective film |
q | serves as a support for the adjusting buffer Pos. 7 |
17 - | Cap |
q | to secure the flap lock cable Pos. 18 clipped onto the flap lock Pos. 20 |
18 - | Flap lock cable |
q | removing and installing → Chapter |
19 - | 9 Nm |
q | self-locking |
q | 4 pieces |
q | replace → Electronic Catalogue of Original Parts |
20 - | Flap lock |
q | removing and installing → Chapter |
21 - | Lock carrier |
q | for attaching the flap lock Pos. 20 |
22 - | 3 Nm |
q | 4 pieces |
23 - | 3 Nm |
q | 4 pieces |
24 - | 3 Nm |
q | 4 pieces |