Fabia Mk1
Note
|
1 - | Brake disc |
q | Thickness: 18 mm |
q | Wear limit: 15 mm |
q | always replace axle-wise |
q | unscrew the brake caliper before removing |
q | Do not use force to separate the brake discs from the wheel hub, if necessary use rust solvent; as you could otherwise damage the brake discs. |
2 - | 4 Nm |
3 - | Brake pads |
q | with wear indicator |
– | with a corresponding wear (limit: 2 to 3 mm) the warning light in the dash panel insert lights up |
q | with retaining spring |
q | Install brake pad with a small pad surface on the piston side |
q | Thickness: 17,6 mm (including the support plate) |
q | Wear limit: 2.0 mm without supporting plate |
q | Inspect thickness → BookletFabia |
q | always replace axle-wise |
q | do not unscrew the brake line when replacing the brake pad |
q | removing and installing → Chapter |
q | do not interchange the inside and outside brake pads → Chapter |
q | Observe the instructions for changing the pad → Chapter |
4 - | Brake caliper |
q | removing: |
– | Remove the brake pads → Chapter |
– | Use brake pedal load |
– | Unscrew brake hose from brake caliper |
q | Installing: |
– | Installing brake pads → Chapter |
– | Screw the brake hose onto the brake caliper. |
– | Remove brake pedal load |
– | Bleeding Brake System → Chapter |
q | repairing → Chapter |
q | Observe the instructions for changing the pad → Chapter |
5 - | The rubber bush below |
q | before mounting, coat with lithium grease -G 052 150 A2- |
6 - | Bottom bushing |
q | with slits on one side |
q | before mounting, coat with lithium grease -G 052 150 A2- |
7 - | Bottom distance sleeve |
q | before mounting, coat with lithium grease -G 052 150 A2- |
8 - | Fillister head screw with bottom Allen key, 25 Nm |
q | M8 x 48 |
9 - | Air deflector |
10 - | 10 Nm |
q | for air deflector |
11 - | Fillister head screw with top Allen key, 25 Nm |
q | M8 x 59 |
12 - | Top distance sleeve |
q | before mounting, coat with lithium grease -G 052 150 A2- |
13 - | Top bushing |
q | with slits on one side |
q | before mounting, coat with lithium grease -G 052 150 A2- |
14 - | The rubber bush above |
q | before mounting, coat with lithium grease -G 052 150 A2- |
15 - | Tensioning sleeve |
16 - | Brake hose with supports, hollow screw and gasket rings |
q | must be replaced completely, do not dismantle |
q | Tightening torque: 35 Nm |
q | do not unscrew when replacing the brake pad |
17 - | Wheel hub with wheel bearing |
q | for vehicles with ABS the sensor ring is built into the wheel hub |
q | replace after each removal, is destroyed during removal |
q | removing and installing → Chapter |
q | Assignment → Electronic Catalogue of Original Parts |
18 - | 10 Nm |
19 - | Cover plate |
20 - | Wheel-bearing housing |
21 - | ABS wheel speed sensor |
22 - | Allan screw, 8 Nm |
q | for speed sensor ABS |