Fabia Mk1
| – | Installing components for adjusting the clutch clearance without axial needle brearing -Pos. 3-, adjusting washer -Pos. 5- and ATF pump -Pos. 7- → Chapter. |
| – | Set clutch clearance between -K1- and ATF pump → Chapter |
| – | Set clutch clearance between -K2- and ATF pump → Chapter |
| – | Perform control measurement (clutch clearance) → Chapter |
| 1 - | Gearbox housing |
| q | Planetary gear fitted up to small drive shaft → Chapter |
| 2 - | 1st through 3rd gear clutch -K1- with turbine shaft |
| 3 - | Axial needle bearing with washer |
| q | check fitting position → Chapter |
| q | do not install to adjust the clutch clearance |
| 4 - | Reverse gear-clutch -K2- |
| 5 - | Adjusting washer |
| q | do not install to adjust the clutch clearance |
| 6 - | Gasket |
| q | for ATF pump |
| 7 - | ATF-pump |
| 8 - | 20 Nm |
