Fabia Mk1
|
| 1 - | Exhaust manifold |
| 2 - | 30 Nm |
| q | replace |
| q | Coat thread and contact surfaces with hot bolt paste -G 052 112 A3- |
| 3 - | Intake manifold |
| 4 - | from charge-air cooler |
| 5 - | Gasket |
| q | replace |
| 6 - | 25 Nm |
| 7 - | Gasket |
| q | Check fitting position |
| 8 - | Support |
| q | for cover plate → Chapter (Pos. 10) |
| 9 - | Washer |
| 10 - | Cover plate |
| q | fasten in the holder → Chapter (Pos. 8) |
| 11 - | 10 Nm |
| 12 - | Circlip |
| 13 - | Vacuum reservoir |
| q | for the charge pressure control valve |
| q | Component part of the exhaust turbocharger cannot be replaced separately |
| 14 - | of valve block |
| q | Connection diagram for vacuum hoses → Chapter |
| 15 - | Release rod |
| 16 - | 10 Nm |
| q | coat with locking agent -D 000 600 A2- |
| 17 - | Support |
| 18 - | Connecting hose |
| q | from rear charge air pipe → Chapter |
| 19 - | Hollow screw, 15 Nm |
| 20 - | Sealing ring |
| q | replace |
| 21 - | of valve block |
| q | Connection diagram for vacuum hoses → Chapter |
| 22 - | Connection fittings, 40 Nm |
| q | replace |
| q | Coat thread and contact surfaces with hot bolt paste -G 052 112 A3- |
| 23 - | Oil return line, 30 Nm |
| q | to cylinder block |
| 24 - | 15 Nm |
| 25 - | Gasket |
| q | replace |
| 26 - | Pre-exhaust pipe |
| 27 - | 25 Nm |
| q | replace |
| 28 - | Exhaust gas turbocharger |
| q | removing and installing → Chapter |
| 29 - | Connection fittings, 30 Nm |
| q | replace |
| q | Coat thread and contact surfaces with hot bolt paste -G 052 112 A3- |
| q | before connecting the oil feed line fill connection fitting with engine oil. |
| 30 - | Oil feed line, 22 Nm |
| q | from oil filter bracket → Chapter |
| q | Check oil feed line for continuity before installing. |
| q | removing and installing → Chapter |
