Fabia Mk1
Engine compartment - Overview of fitting locations |
Components A through H are not represented in the overview figure. |
A - | Diesel direct injection system relay -J322- |
q | on relay carrier → Fig. |
B - | Glow plug relay -J52- |
q | on relay carrier → Fig. |
C - | Low heat output relay -J359- |
q | on relay carrier → Fig. |
D - | High heat output relay -J360- |
q | on relay carrier → Fig. |
E - | Fuel pump relay -J17- |
q | on relay carrier → Fig. |
F - | Accelerator pedal position sender -G79- |
q | in footwell on the accelerator pedal → Fig. |
G - | Brake light switch -F- and brake pedal switch -F47- |
q | in footwell on the brake pedal → Fig. |
H - | Clutch pedal switch -F36- |
q | in footwell on the clutch pedal → Fig. |
1 - | Valve block |
q | Component parts of the valve block are: |
q | Exhaust gas return valve -N18- |
q | Solenoid valve for charge pressure control -N75- |
q | for engine with identification characters AMF: changeover valve for intake manifold flap -N239- |
2 - | Intake manifold flap motor -V157- |
q | for engine with identification characters BNM, BNV |
3 - | Mechanical exhaust gas recirculation valve |
q | at the induction pipe with the intake manifold flap |
4 - | Coolant temperature sender -G62- |
5 - | Air mass meter -G70- |
6 - | Engine control unit -J248- |
7 - | Fuel temperature sender -G81- |
8 - | Connector |
q | 3-pin, grey |
q | for engine speed sender -G28- |
q | 3-pin, black |
q | for camshaft position sensor -G40- |
9 - | Engine speed sender -G28- |
q | removing and installing → Chapter |
10 - | Camshaft position sensor -G40- |
11 - | Intake manifold pressure sender -G71- with intake manifold temperature sender -G72- |
12 - | Fuel filter |
q | The fuel filter from the engine with identification characters AMF is shown in the figure |
q | repairing → Chapter |
|
|