skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Extract fuel from the fuel tank > < Fuel tank with component parts - Summary of components
Fuel filter - Summary of components
   
Fuel filter - Summary of components
The fuel flow direction is indicated with arrows on the hoses, on the glow valve and the fuel filter.
1 - Return-flow hose
q   from the tandem pump
q   blue marking
2 - Intake hose
q   to the tandem pump
q   white marking
3 - Retaining clip
q   for engine with identification characters AMF
q   replace if damaged
4 - Preheating valve
q   for engine with identification characters AMF
q   Fitting position: Arrow points to fuel tank
q   if the filter is replaced remove retaining clip and preheating valve with the fuel lines connected
q   Temperature below +15 °C: access to filter open
q   Temperature above +31 °C: access to filter closed
5 - Return-flow hose
q   for engine with identification characters AMF: to the fuel cooler → Chapter (Pos. 11)
q   for engine with identification characters BNM, BNV: to the fuel tank
q   blue marking
6 - Intake hose
q   from fuel tank
q   white marking
7 - Fuel filter
q   for engine with identification characters AMF
q   fill with diesel fuel before fitting
q   do not interchange connections
q   replace if damaged
q   removing and installing → Fig.
8 - Gasket
q   for engine with identification characters AMF
q   replace if damaged
9 - Drain plug
q   for engine with identification characters AMF
q   to ventilate remove the retaining clip of the preheating valve and remove preheating valve with the fuel lines connected
q   release and drain approx. 0.1 litre fluid (catch)
10 - Fuel filter
q   for engine with identification characters BNM, BNV
q   fill with diesel fuel before fitting
q   do not interchange connections
q   replace if damaged
q   removing and installing → Fig.
11 - Connecting hose
q   for engine with identification characters BNM, BNV
12 - Combination valve
q   for engine with identification characters BNM, BNV
13 - 25 Nm
14 - Support
15 - Plastic insert
q   with holder → Chapter (Pos. 14) are one replacement part

   
Removing and installing fuel filter
  Note
The fuel filter from the engine with identification characters AMF is shown in the figure.
For engine with identification characters AMF
–  Remove the preheating valve with the fuel hoses fitted (pull out retaining clip).
Continued for all engines
–  Remove fuel feed line.
–  Push the retaining lugs -arrows- of the plastic insert outwards.
–  Remove fuel filter from the top.
  S20-0097

Extract fuel from the fuel tank > < Fuel tank with component parts - Summary of components