skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive plate > < Cylinder block made out of aluminium - summary of components

Fabia Mk1

Replacing gasket ring for crankshaft -on the belt pulley side-
Replacing gasket ring for crankshaft -on the belt pulley side-
Special tools and workshop equipment required
t  Gasket ring extractor -T 30003-
t  Bushing -T10022-
t  Thrust piece -T10022/1-
t  Spindle -T10022/2-
Removing
–  Remove main drive toothed belt → Chapter.
–  Remove crankshaft - toothed belt sprocket.
–  To guide the gasket ring extractor, screw the fixing screw for the crankshaft - toothed belt sprocket into the crankshaft up to the stop.
–  Turn inner part of gasket ring extractor -T 30003- two turns (approx. 3 mm) out of the outer part and lock with knurled screw.
   
–  Oil the thread head of the gasket ring extractor, position and forcely screw into the gasket ring as far as possible.
–  Release knurled screw and turn the inner side against the crankshaft until the gasket ring is pulled out.
Install
–  Lightly oil the sealing lip of the gasket ring.
  S13-0269
–  Position the bushing -T10022- on the crankshaft stub and screw in with spindle -T10022/2- up to the stop.
–  Slide gasket ring over the bushing -T10022-.
  S13-0506
–  Press in gasket ring with pressure plate -T10022/1- up to the stop.
–  Install the main drive toothed belt → Chapter.
  S13-0507

Removing and installing drive plate > < Cylinder block made out of aluminium - summary of components