Fabia Mk1
Removing and installing parts of the injection system |
1 - | Top part of intake manifold |
2 - | Connector |
q | 81-pin |
q | Insert or remove plug when the ignition is switched off |
q | unlock for removing |
3 - | Engine control unit-J220- |
q | Fitting location → Chapter |
q | removing and installing → Chapter |
4 - | Connector |
q | 40-pin |
q | Insert or remove plug when the ignition is switched off |
q | unlock for removing |
5 - | Air filter |
q | Summary of components → Chapter |
6 - | 10 Nm |
7 - | to air guide pipe |
8 - | Air intake hose |
q | to secondary air pump -V101- |
9 - | 10 Nm |
10 - | Connector |
q | for coolant temperature sender -G62- |
11 - | Coolant temperature sender -G62- |
q | before removing, reduce pressure in cooling system if necessary |
12 - | Retaining clip |
q | check correct fitting |
13 - | Connector |
q | 3-pin, grey |
q | for engine speed sender -G28- |
14 - | O-ring |
q | replace if damaged |
15 - | Engine speed sender -G28- |
16 - | Lambda probe downstream of catalytic converter -G130-, 50 Nm |
q | coat only thread with hot bolt paste -G 052 112 A3-; hot bolt paste must not get into the slot of the probe body |
17 - | Plug connection for lambda probe downstream of catalytic converter |
q | 4-pin |
18 - | Lambda probe upstream of catalytic converter -G39-, 50 Nm |
q | coat only thread with hot bolt paste -G 052 112 A3-; hot bolt paste must not get into the slot of the probe body |
q | Fitting location: in the exhaust manifold |
19 - | Plug connection for lambda probe upstream of catalytic converter |
q | 6-pin |
20 - | Bottom part of intake manifold |
q | Summary of components → Chapter |
21 - | Fuel rail with injection valves |
q | Summary of components → Chapter |
22 - | Fuel return-flow line |
q | blue |
q | secure with spring strap clamps |
q | Check fitting position |
q | to the fuel delivery unit in the fuel tank |
23 - | Fuel feed line |
q | black |
q | secure with spring strap clamps |
q | Check fitting position |
q | from fuel filter |
24 - | Gasket |
q | replace if damaged |
q | Check fitting position |
25 - | To crankcase vent valve |
26 - | Air intake hose |