Fabia Mk2
| Summary of components of the brake caliper of the brake at the rear |
Note| t | Install the complete repair set when undertaklng repairs. |
| t | The brake calipers must be pre-bled before installing them in the vehicle (without brake pads) in case of a repair or when replacing them with new brake calipers → Chapter. |
| t | Thinly coat brake cylinder, piston and gasket ring with lithium grease -G 052 150 A2-. |
| 1 - | Self-locking screw, 35 Nm |
| q | replace after each removal |
| q | counterhold on the guide bolt when releasing and tightening |
| 2 - | Dust cap |
| 3 - | Vent valve, 10 Nm |
| q | thinly coat thread with lithium grease -G 052 150 A2- before screwing in |
| 4 - | Guide bolt |
| q | grease before fitting the collar - Pos. 5 |
| q | use the grease packing supplied with the repair kit |
| 5 - | Collar |
| q | pull onto brake carrier and guide bolt |
| 6 - | Brake carrier with guide bolts and boots |
| q | must be assembled with sufficient grease on the guide bolt, supplied as a spare part |
| q | if there is any damage to the boots or guide bolts fit a repair set (use the enclosed grease packing to grease the guide bolts) |
| 7 - | Collar |
| q | removing and installing → Chapter |
| q | do not damage when inserting the piston |
| 8 - | Piston with automatic adjusting device |
| q | removing and installing → Chapter |
| 9 - | Sealing ring |
| q | removing and installing → Chapter |
| 10 - | Brake caliper housing with lever for the handbrake cable |
| q | replace brake caliper housing if the lever for the handbrake cable is not sealed |
| q | pre-bleed brake caliper housing after undertaking replacement → Chapter |
