Removing and Installing Drive Shaft, Output Shaft, Differential Gear, and Shift Forks
Removing and installing the drive shaft, output shaft, differential gear and shift forks |
1 - | Differential gear |
q | disassembling and assembling → Chapter |
2 - | O-ring |
q | 4 pieces |
q | always replace → Electronic Catalogue of Original Parts |
3 - | Output shaft |
q | disassembling and assembling → Chapter |
4 - | reverse shaft support |
q | disassembling and assembling → Chapter |
5 - | Reverse shaft |
q | disassembling and assembling → Chapter |
6 - | Drive shaft |
q | disassembling and assembling → Chapter |
7 - | Gearshift fork reverse gear |
q | disassembling and assembling → Chapter |
q | Fitting position → Chapter |
8 - | 25 Nm |
9 - | Shift mechanism |
q | (Gearshift forks) |
q | disassembling and assembling → Chapter |
10 - | Clutch housing |
q | repairing → Chapter |
11 - | 25 Nm and torque a further 90° |
q | 4 nuts for bearing support |
q | always replace → Electronic Catalogue of Original Parts |
12 - | Flange shaft with pressure spring |
q | removing and installing → Chapter |
q | complete → Chapter |
13 - | 25 Nm |