Fabia Mk2
Note| t | Grease bearing points and friction surfaces. |
| t | Assign the grease via the → Electronic Catalogue of Original Parts. |
| 1 - | Gearshift shaft |
| q | when shifting from the 5th gear to the 4th gear, the screw Pos. 5 guides the gearshift shaft into the 4th gear gate via the leg -arrow- |
| q | pay attention to correct assignment → Electronic catalogue of original parts |
| 2 - | Stop ring |
| 3 - | Ball sleeve |
| q | removing → Fig. |
| q | inserting → Fig. |
| 4 - | Shift cover |
| q | with locking angle for setting the gearshift mechanism |
| q | Remove locking angle → Fig. |
| q | Press in locking angle → Fig. |
| q | pay attention to correct assignment → Electronic catalogue of original parts |
| 5 - | 15 Nm |
| 6 - | Reversing light switch -F4-, 20 Nm |
| q | Grease peg lightly with grease for plug serration of clutch disc -G 000 100- |
| 7 - | Reversing lever |
| q | Fitting position → Chapter |
| q | as of 06.07 the relay lever is made of plastic (Fabia II, Roomster) |
| q | Removing and installing plastic relay lever together with cable lock (Fabia II, Roomster) → Chapter |
| q | If the relay lever is made of plastic, neither the bushings pos. 8 nor the lock washer pos. 13 are required |
| q | after fitting, set the shift mechanism (Fabia II, Roomster) → Chapter, (Rapid) → Chapter |
| 8 - | Bushing |
| q | is not required, if the relay lever is made of plastic |
| 9 - | Sealing ring |
| q | lever out with screwdriver |
| q | installing → Fig. |
| q | Fill half the space between the sealing lips and dust lips with sealing grease -G 052 128 A1- |
| 10 - | Cap |
| q | for gearbox bleeder |
| 11 - | 20 Nm |
| q | always replace → Electronic Catalogue of Original Parts |
| 12 - | Gearshift lever |
| q | insert in such a way that the interrupted spacing of the teeth matches the gearshift shaft |
| q | may be replaced with the gearshift mechanism mounted |
| q | Fitting position → Chapter |
| q | after fitting, set the shift mechanism (Fabia II, Roomster) → Chapter, (Rapid) → Chapter |
| 13 - | Lock washer |
| q | replace after each disassembly → electronic catalogue of original parts |
| q | is not required, if the relay lever is made of plastic |
| 14 - | Screw cap |
| 15 - | Spring |
| q | if present, insert in the screw cap Pos. 14 |
|
|
|
|
|
|
