Skoda Workshop Service and Repair Manuals > Fabia Mk2 > Power transmission | Gearbox 02T | Clutch, control | Clutch control | Removing and installing the bracket without the master cylinder (Fabia II 2011 ?; Roomster 2011 ?)

Removing and installing the bracket without the master cylinder (Fabia II 2011 ►; Roomster 2011 ►)

Special tools and workshop equipment required

t	Pliers -T10005-

Removing

–	Removing the footwell vent → Heating and Air Conditioning; Rep. gr.87.

–	If present, release screws -arrows- and remove crash strut -A-.

–	Put steering wheel in the highest position.

–	Remove clutch pedal switch -F36--1- → Chapter.

–	Unscrew the top fixing nut -arrow- for the bracket. To do so, position an long extension on the nut in the opening between the dash panel -2- and the bottom steering column trim panel -3-.

Unlock the actuating rod/master cylinder from the clutch pedal as follows:

–	Pull clutch pedal slightly into the passenger compartment.

–	Press together both sides of the support using the pliers -T10005--arrows-.

–	Unscrew the two lower fixing nuts -arrows-.

–	Remove the bracket -A- from the front wall -B-.

l	The master cylinder is locked into position with the bracket.

l	The assistance of a 2nd mechanic is required to counterhold it when removing the bracket from the engine compartment.

Install

Installation is performed in the reverse order, pay attention to the following points:

Note

Position self-locking nuts -1- and -2- for bracket -3- on front wall.

–	The support -A- must be located on the actuating rod -B- of the master cylinder.

–	To click in the support -A-, press the clutch pedal towards the front wall in -direction of arrow-. While doing so, make sure it catches correctly in the support.

–	Install the clutch pedal switch -F36- → Chapter.

–	If present, install crash strut -A- → Chapter.

–	Install the footwell vent → Heating and Air Conditioning; Rep. gr.87.

Skoda Workshop Service and Repair Manuals