Fabia Mk2
| Removing and installing the drive shaft, output shaft, differential gear, shift mechanism and gearshift forks |
| 1 - | Differential gear |
| q | disassembling and assembling → Chapter |
| 2 - | Gearbox housing |
| q | is made out of aluminium or magnesium → Chapter |
| q | on gearboxes made out of aluminium as of production date 12.06 the adjusting washer S1 for outer ring/tapered-roller bearing is not fitted → Chapter |
| q | Bearing pedestal for outer ring/tapered-roller bearing is adapted |
| q | Assignment → Electronic Catalogue of Original Parts |
| q | repairing → Chapter |
| 3 - | Oil drain plug |
| q | different versions: |
| Oil drain plug with internal serration - 24 Nm |
| Oil drain plug with hexagon socket head - 32 Nm |
| 4 - | Flange shaft with pressure spring |
| q | removing and installing → Chapter |
| q | complete → Chapter |
| 5 - | Conical screw, 25 Nm |
| 6 - | 5 Nm + torque a further 90° |
| q | self-locking |
| q | always replace → Electronic Catalogue of Original Parts |
| q | to secure the bearing support for grooved ball bearing with the drive shaft and output shaft -Pos. 16- |
| 7 - | 23 Nm |
| q | for gearshift mechanism -Pos. 15- |
| q | self-locking |
| q | always replace → Electronic Catalogue of Original Parts |
| 8 - | O-ring |
| q | always replace → Electronic Catalogue of Original Parts |
| 9 - | Bearing pins |
| 10 - | 5 Nm + torque a further 90° |
| q | always replace → Electronic Catalogue of Original Parts |
| 11 - | Gearshift shaft with cover |
| q | disassembling and assembling → Chapter |
| 12 - | 5 Nm + torque a further 90° |
| q | always replace → Electronic Catalogue of Original Parts |
| 13 - | 5 Nm |
| 14 - | Transmission neutral sender -G701- |
| q | for vehicles with start-stop system |
| 15 - | Reversing light switch -F4-, 20 Nm |
| 16 - | Sealing ring |
| q | if present, replace → Electronic Catalogue of Original Parts |
| 17 - | Shift mechanism |
| q | Gearshift forks |
| q | disassembling and assembling → Chapter |
| 18 - | Drive shaft and output shaft with bearing support for grooved ball bearing |
| q | Always replace bearing support after removing → Electronic Catalogue of Original Parts |
| q | pressing off and on bearing support → Chapter |
| q | Disassembling and assembling the drive shaft → Chapter |
| q | Disassembling and assembling the output shaft → Chapter |
| 19 - | Reverse shaft support |
| q | with support |
| 20 - | Reverse gear |
| 21 - | Screw |
| q | for reverse shaft support -Pos. 17- |
| q | M6: 5 Nm + torque a further 90° |
| q | M8: 25 Nm + torque a further 45° |
| q | always replace → Electronic Catalogue of Original Parts |
