skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Summary of components - Control cables > < Removing and installing gearshift knob and shift lever collar (Fabia II, Roomster)

Fabia Mk2

Summary of components - Shift lever and shift housing
   
Summary of components - Shift lever and shift housing
  Note
Grease bearing and friction surfaces with grease -G 000 450 02-.
1 - Lock washer
q   removing and installing → Fig.
2 - Pressure spring
3 - Gasket
q   between shift housing and underbody
q   self-adhesive
q   stuck onto the shift housing
4 - Shift lever
5 - Damping
q   removing and installing → Fig.
6 - Shift housing
7 - Insulating washer
q   must be present in the round slot -arrow- at the shift lever -Pos. 4-
8 - Gasket
q   replace → Electronic Catalogue of Original Parts
9 - Cover
q   bend up tabs for removing
q   replace → Electronic Catalogue of Original Parts
10 - Bush
11 - Selector cable
q   pressed onto selector angle plate
q   slacken from selector angle plate within the shift mechanism
q   press onto selector angle plate within the shift mechanism
q   Fitting position → Chapter
q   after installing, set shift mechanism:
t  Fabia II, Roomster → Chapter
t  Rapid → Chapter
12 - Shift cable
q   pressed onto the shift lever guide
q   slacken from the shift lever guide within the shift mechanism
q   press onto the selector angle guide within the shift mechanism
q   Fitting position → Chapter
q   after installing, set shift mechanism:
t  Fabia II, Roomster → Chapter
t  Rapid → Chapter
13 - 23 Nm
q   4 pieces

   
Removing and installing lock washer
–  When removing and installing the circlip -A- pull the gearshift lever in the -direction of the arrow A- while simultaneously pressing the spring down with a screwdriver up to the stop in the -direction of the arrow B-.
  Note
t  Mounting slot in shift lever for lock washer must be visible.
t  Release spring carefully.
  V34-2958
Removing and installing damping -arrow-
–  Press the pressure spring leg -A- to the left until it is located next to the damping -arrow-.
–  Press the shift lever to the lift and pull off the damping.
l  After installing the damping, the pressure spring arms -A- and -B- must rest on the damping -Pfeil-.
  N34-10832

Summary of components - Control cables > < Removing and installing gearshift knob and shift lever collar (Fabia II, Roomster)