Fabia Mk2
| Oil pan, oil strainer, slide valve body, internal wiring looms - Summary of components |
| 1 - | ATF inspection plug M10, 27 Nm |
| q | Replace gasket ring Pos. 2 |
| q | Inspecting ATF level, if necessary topping up → Chapter |
| 2 - | Sealing ring |
| q | replace → Electronic Catalogue of Original Parts |
| 3 - | Overflow tube, 2 Nm |
| q | screw with 5 mm Allen key into the oil pan |
| 4 - | Oil pan |
| q | removing and installing → Chapter |
| 5 - | 7 Nm |
| q | 8 pieces for attaching the oil pan with the oil pan gasket to the gearbox housing |
| q | Tighten oil pan screws crosswise in several stages |
| 6 - | Gasket |
| 7 - | Magnet |
| q | 2 magnets in the beads of the oil pan |
| q | clean before installation |
| 8 - | 11 Nm |
| q | 3 pieces for attaching oil strainer to slide valve body |
| 9 - | Oil filter |
| q | removing and installing → Chapter |
| 10 - | M6 screw |
| q | 12 screws with different lengths for attaching the slide valve body to the gearbox |
| q | replace → Electronic Catalogue of Original Parts |
| q | Pay attention to assignment → Chapter |
| 11 - | Slide valve body |
| q | removing and installing → Chapter |
| q | Marking of solenoid valves → Chapter |
| q | Assignment → Electronic Catalogue of Original Parts |
| 12 - | 6 Nm |
| 13 - | Gearbox input r.p.m. sender -G182- |
| q | with cable and 2-pin plug connection |
| q | removing and installing → Chapter |
| 14 - | 7 Nm |
| 15 - | Gearbox output r.p.m. sender -G195- |
| q | with cable and 2-pin plug connection |
| q | removing and installing → Chapter |
| 16 - | Gearbox housing |
| 17 - | ATF bleeder |
| 18 - | ATF radiator |
| q | removing and installing → Chapter |
| 19 - | Multi-function switch -F125- |
| q | is checked by self-diagnosis |
| q | removing and installing → Chapter |
| q | adjust → Chapter |
| 20 - | Sealing ring |
| q | replace → Electronic Catalogue of Original Parts |
| 21 - | ATF drain plug M18, 40 Nm |
| 22 - | Lever |
| q | for inside selector lever shaft at slide valve body |
| q | removing and installing → Chapter |
| 23 - | Washer |
| 24 - | 10 Nm |
| q | Pay attention to fitting location of the nut → Chapter |
| 25 - | Large spring |
| 26 - | Small spring |
| 27 - | Shock absorber piston |
| 28 - | Wiring loom with 8-pin plug and integrated gearbox oil temperature sender -G93- |
| q | with O-ring at connector |
| q | Replace O-ring → Electronic Catalogue of Original Parts |
| q | connected components → Chapter |
| q | removing and installing → Chapter |
| 29 - | 6 Nm |
| 30 - | Wiring loom with 14-pin plug |
| q | with O-ring at connector |
| q | Replace O-ring → Electronic Catalogue of Original Parts |
| q | connected components → Chapter |
| q | removing and installing → Chapter |
| 31 - | 6 Nm |
