skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Fuel supply, gas operation > < Removing and installing radiator

Fabia Mk2

Removing and installing coolant pump
Removing and installing coolant pump
  Note
t  The integrated gasket of the coolant pump must not be separated from the pump.
t  If damage or leak present, replace coolant pump with gasket completely.
Special tools and workshop equipment required
t  The adapted wrench for the water pump and power-assisted steering -MP1-308-
   
Because of modified fixing screws for the belt pulley of the coolant pump, these large curvatures must be filed open:
   Dimension -a- at least 1 mm.
Removing
–  Drain coolant → Chapter.
–  Only slacken the bolts of the coolant pump belt pulley, do not remove them.
–  Remove V-ribbed belt → Chapter.
–  Remove belt pulley from the coolant pump.
–  Unscrew bolts of the coolant pump.
–  Remove the coolant pump from the cylinder block.
Install
Installation is carried out in the reverse order. Pay attention to the following:
Tightening torques: → Chapter
t  Inspect the plastic rotor of the coolant pump for tears.
–  Top up coolant → Chapter.
  S19-0146

Fuel supply, gas operation > < Removing and installing radiator