skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the sender for fuel gauge displayG > < Extract fuel from the fuel tank

Fabia Mk2

Removing and installing fuel delivery unit
Removing and installing fuel delivery unit
Special tools and workshop equipment required
t  Wrench for union nut -MP1-227 (3217)-
Condition
l  The ignition must be switched off and the ignition key must be withdrawn.
l  The fuel tank must not be more than 3/4 full.
Removing
  Note
t  Observe the safety instructions before starting fitting work → Chapter.
t  Observe rules for cleanliness → Chapter.
t  If necessary drain the fuel tank → Chapter.
For vehicles Fabia II
–  Remove right rear seat → Body Work; Rep. gr.72.
For vehicles Roomster
–  Fold back the middle and rear seat and position vertically → Body Work; Rep. gr.72 and fold back the floor covering.
Continued for all vehicles
–  Remove the cover from the fuel delivery unit.
–  Disconnect the plug as well as the feed line and the return-flow line from the flange of the fuel delivery unit.
  Note
Always press in the securing ring in order to unlock the fuel lines → Chapter.
  WARNING
The fuel feed line is pressurized! Place a clean cleaning cloth around the connection point before detaching hose connections. Reduce pressure by carefully releasing the connection point.
   
–  Unscrew union nut with wrench for union nut -MP1-227 (3217)-.
–  Pull the fuel delivery unit and the gasket ring out of the opening of the fuel tank.
  Note
You must empty the old delivery unit before disposing of it if you wish to replace the fuel delivery unit.
Install
Installation of the fuel delivery unit occurs in reverse order to removal. Pay attention to the following:
  Note
t  When installing the fuel delivery unit, ensure that the float arm of the sender for fuel gauge display is not bent.
t  Insert dry gasket ring of the fuel delivery unit into the opening of the fuel tank.
t  Only moisten gasket ring with fuel before assembly of the fuel delivery unit.
t  Fitting position of flange of fuel delivery unit ► 03.10 → Fig..
t  Fitting position of flange of fuel delivery unit 04.10 ► → Fig..
t  Do not interchange feed line and return-flow line.
t  Make sure the fuel hoses fit tightly.
t  After installing the fuel delivery unit, check whether the feed, return-flow and vent lines are clipped in place on the fuel tank.
  S20-0054

Removing and installing the sender for fuel gauge displayG > < Extract fuel from the fuel tank