skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Oil feed line, oil return-flow line and support for exhaust turbocharger - Summary of components > < Removing and installing engine oil cooler

Fabia Mk2

Removing and installing oil pressure switchF1
Removing and installing oil pressure switch -F1-
Removing
–  Remove engine cover → Chapter.
   
–  Remove the hose for the crankcase ventilation -1-, to do so press together the release buttons.
–  Release vacuum hoses -arrows-.
–  Slacken hose clamp -3- and remove air guide pipe from air filter housing.
–  Release screw -2-, swivel suction hose with connection fitting towards the rear and detach from exhaust gas turbocharger.
  A21-10437
–  Release screws -2- and -3- and remove engine lifting eye -1-.
–  Disconnect plug connection -arrow-.
–  Screw out oil pressure switch -F1-.
Install
l  Tightening torques: → Anchor.
Installation is performed in the reverse order, pay attention to the following points:
  Note
Replace gasket ring.
–  Install inlet connection.
–  Install vacuum line.
  A17-10550

Oil feed line, oil return-flow line and support for exhaust turbocharger - Summary of components > < Removing and installing engine oil cooler