Skoda Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing oil pressure switchF1 >
< Removing and installing the oil filter holder with the engine oil cooler
Fabia Mk2
Power unit
1.6/55; 66; 77 kW TDI CR Engine
Engine lubrication / Removing and installing parts of the lubrication system
Removing and installing engine oil cooler
Removing and installing engine oil cooler
Removing and installing engine oil cooler
Special tools and workshop equipment required
t
Catch pan, e.g. -VAS 6208-
t
Old oil collecting and suction equipment, e.g. -V.A.G 1782-
t
Pliers for spring strap clamps
Removing
–
Remove engine cover
→ Chapter
.
–
Draining coolant:
t
Fabia II, Roomster, Rapid
→ Chapter
.
t
Octavia II, Superb II, Yeti
→ Chapter
.
–
Remove air filter housing:
t
Fabia II, Roomster, Rapid
→ Chapter
.
t
Octavia II, Superb II, Yeti
→ Chapter
.
–
Remove oil filter insert
-3-
:
t
→ BookletFabia II
.
t
→ BookletRoomster
.
t
→ BookletOctavia II
.
t
→ BookletSuperb II
.
t
→ BookletYeti
.
t
→ BookletRapid
.
–
Release screws
-arrows-
.
–
Take the engine oil cooler out of the housing.
Install
Installation is performed in the reverse order, pay attention to the following points:
Note
t
Replace gaskets, gasket rings and O-rings.
t
Hose connections as well as charge air pipes and charge air hoses must be free of oil and grease before being installed.
t
The hose connections are secured with spring-type clips. In the event of repairs only use spring-type clips.
–
Insert new gaskets Pos. 8
→ Chapter
-1-
in the supports of the oil filter holder.
–
Carefully position the engine oil cooler onto the dowel sleeves.
–
Push the engine oil cooler on the ends of the dowel sleeves
-1-
.
–
Insert new screws and screw in up to the stop.
–
Tighten the screws
-arrows-
crosswise in 3 stages:
1st stage:
only tighten by hand
2nd stage:
5 Nm
3rd stage:
11 Nm
–
Install oil filter insert, fill with engine oil and check the oil level:
t
→ BookletFabia II
.
t
→ BookletRoomster
.
t
→ BookletOctavia II
.
t
→ BookletSuperb II
.
t
→ BookletYeti
.
t
→ BookletRapid
.
–
Top up or change coolant if the engine oil cooler was replaced:
t
Fabia II, Roomster, Rapid
→ Chapter
.
t
Octavia II, Superb II, Yeti
→ Chapter
.
Power unit
1.6/55; 66; 77 kW TDI CR Engine
Engine lubrication / Removing and installing parts of the lubrication system
Removing and installing engine oil cooler
Removing and installing oil pressure switchF1 >
< Removing and installing the oil filter holder with the engine oil cooler