skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing crankshaft seal on belt pulley side > < Cylinder block, sealing flange and flywheel

Fabia Mk2

Cylinder block - Summary of components
   
Cylinder block - Summary of components
  WARNING
The crankshaft must not be removed. Merely releasing the crankshaft bearing cover screws will result in deformations of the bearing seats of the cylinder block. These deformations reduce the bearing clearance. Even if the bearing shells were not replaced, the changed bearing clearance may cause damage to the bearing.
If the bearing cover screws have been released, replace the complete cylinder block together with the crankshaft.
It is not possible to measure the crankshaft bearing clearance under workshop conditions.
  Note
Repairs to the clutch → Gearbox; Rep. gr.30.
1 - Fixing screw
q   for crankshaft - belt pulley
q   replace
q   The clamping surface of the fixing screw must be free of grease and oil.
q   insert oiled (thread)
q   tighten → Chapter
2 - Belt pulley
q   Clamping surfaces must be free of oil and grease.
q   Removing and installing ribbed V-belt → Chapter
3 - Gasket ring for crankshaft in timing case
q   replace → Chapter
4 - Spacer sleeve
q   Clamping surfaces must be free of oil and grease.
q   install with new O-ring -Position 5-
5 - O-ring
q   replace
q   in the spacer sleeve -Position 4-
6 - Cylinder block
q   Aluminium cylinder block with timing case shown for engine with identification characters BTS, CFNA
q   for engine with identification characters CLSA made of grey cast iron
7 - 60 Nm + torque a further 90° (1/4 turn)
q   replace
8 - Flywheel/drive plate
q   removing and installing flywheel → Chapter
q   removing and installing driver disc → Chapter
9 - Intermediate plate
q   must be positioned on dowel sleeves
q   do not damage during assembly work
10 - 12 Nm
q   replace
11 - Sealing flange with rotor and gasket ring
q   always replace complete with rotor and gasket ring
q   pay attention to different versions for manual gearbox and automatic gearbox → Chapter
q   replace the sealing flange for the crankshaft → Chapter
12 - Engine speed sender -G28-
q   with captive screw
q   Tightening torque: 5 Nm
q   Pay attention to the part number
q   removing and installing → Chapter

   

Replacing crankshaft seal on belt pulley side > < Cylinder block, sealing flange and flywheel