skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Tightening process of the screw for crankshaft belt pulley > < Cylinder block - Summary of components

Fabia Mk2

Replacing crankshaft seal on belt pulley side
Replacing crankshaft seal on belt pulley side
Special tools and workshop equipment required
t  Gasket ring extractor -MP1-226 (3203)-
t  Assembly device -T10117-
t  Counterholder -T30004 (3415)-
t  Bolt -T30004/1 (3415/1)-
Removing
–  Remove the bottom part of the right wheelhouse liner → Body Work; Rep. gr.66.
–  Remove V-ribbed belt → Chapter.
   
–  Release fixing screw for crankshaft belt pulley.
   Counterhold crankshaft belt pulley with counterholder -T30004 - and bolt -T30004/1-.
–  Release the fixing screw and remove the belt pulley from the crankshaft.
–  Unscrew inner part of the gasket ring extractor -MP1-226- three turns (approx. 5 mm) out of the outer part and lock with knurled screw.
  S13-0409
–  Oil the thread head of the gasket ring extractor -MP1-226-, position and forcefully screw it into the gasket ring as far as possible.
–  Release knurled screw and turn the inner side against the crankshaft until the gasket ring is pulled out.
–  Remove the spacer sleeve from the crankshaft journal and clean the clamping surfaces of the crankshaft chain sprocket.
Install
  Note
t  Install new repair set → Chapter (diamond coated washers and spacer sleeve).
t  Make sure that the clamping surfaces of the fixing screw, the belt pulley, the diamond coated washers, the spacer sleeve and the crankshaft chain sprocket are free of oil and grease.
–  Replace the O-ring in the spacer sleeve → Chapter-Position 4-.
  S13-0410
–  First of all push a new spacer sleeve -3- and washer (inner diameter 23 mm) -2- onto the fixing screw -1-.
–  Screw the fixing screw -1- by about 2 turns into the crankshaft.
–  Push the washer -2- and the bushing -3- onto the crankshaft journal up to the stop.
–  Release fixing screw (at the same time press the spacer sleeve against the crankshaft).
  N13-10131
–  Position the bushing -T10117/2- in front of the spacer sleeve and slide the gasket ring onto the spacer sleeve.
–  Remove the sleeve -T10117/2- from the bushing.
  S13-0438
–  Press the gasket ring with the assembly device -T10117- by striking uniformly up to the stop in the timing case.
–  Tighten screw for crankshaft belt pulley → Chapter.
Further installation occurs in a similar way in reverse order to removal.
  S13-0437

Tightening process of the screw for crankshaft belt pulley > < Cylinder block - Summary of components