skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive plate > < Tightening process of the screw for crankshaft belt pulley

Fabia Mk2

Removing and installing flywheel
Removing and installing flywheel
Special tools and workshop equipment required
t  Counterholder -MP1-223 (3067)-
or
t  Engine mount -MP1-202 (VW 540)-
t  Bushing -T30010 (VW 540/1B)-
t  Flywheel lock -MP1-504-
Removing
l  Gearbox is removed.
–  Remove clutch on vehicles with manual gearbox → Gearbox; Rep. gr.30.
   
Engine installed
–  Insert the counterholder -MP1-223 (3067)- into the bore hole on the cylinder block.
l  Fitting position of the tool:
A - for tightening
B - for slackening
  S13-0096
Engine removed
–  Position the flywheel lock -MP1-504- on the starter ring gear of the flywheel disk and turn crankshaft until it rests against the sleeve -T30010-.
Continued for all
–  Release screws and remove flywheel.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
Use new screws for attaching.
1.  Screw in all the screws by hand.
2.  Tighten all the screws crosswise to 60 Nm.
3.  Torque all the screws crosswise a further 90° (1/4 turn).
  S13-0191

Removing and installing drive plate > < Tightening process of the screw for crankshaft belt pulley