skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing airbag control unit J 234 > < Removing and installing front passenger airbag key switch

Octavia Mk1

Removing and installing side airbag units
Removing and installing side airbag units
1 - Backrest rack
2 - 7 Nm
3 - Airbag unit
–  Take out of the backrest rack -1-.
4 - El. wire of the airbag unit
–  Take out of the clip -5-.
5 - Clip for electrical wire of airbag
–  Take out of the backrest rack -1-.
6 - Airbag unit identification sticker
–  Remove backrest rack -1-.
Removing:
–  Remove front seat from vehicle → Chapter.
–  Remove the backrest rack from the seat rack → Chapter.
–  Remove backrest cover → Chapter.
–  Fold open foam upholstery → Chapter.
Install
–  Insert new airbag unit in the backrest rack.
  S69-0069
–  Place the earth strap -1- of the airbag unit -2- beneath the screw below -3-.
–  Tighten the screws -3- of the airbag unit to 7 Nm.
  S69-0070
–  Stick the self-adhesive identification sticker (smaller one) from the airbag unit onto the side of the backrest rack -arrow-.
  S69-0071
–  Secure electrical wiring -1- of the airbag unit to the rack -3- with the cable strap -2-.
  Note
To avoid damaging the electrical wiring of the airbag unit during mounting it is drawn together with adhesive tape. This tape must only be removed after the backrest and seat rack have been fitted → Chapter.
–  Pull onto backrest cover → Chapter.
  S69-0072

Removing and installing airbag control unit J 234 > < Removing and installing front passenger airbag key switch