| Adjust accelerator control |
Note | t
| The throttle control cable is very sensitive to bents and must be handled very carefully when installing. |
| t
| Already a slight bent can lead later on to a fracture while driving. Throttle control cables, which were bent, must therefore not be installed. |
| t
| During installation, make sure that the throttle control cable is aligned between its supports and the traction fixing points. |
| Special tools and workshop equipment required |
| –
| Hook on throttle control cable at accelerator pedal and at the cam disc of the throttle valve control unit. |
| –
| Detach fuse for throttle control cable at the plug-in catch. |
| –
| Press accelerator pedal in full throttle position. |
Note | A second person is required for this purpose or support accelerator pedal with spring expansion rod against the steering wheel. |
| Vehicles fitted with a manual gearbox |
| –
| Adjust throttle control cable by reconnecting the plug-in catch at support in such a way that the full throttle position is achieved at the throttle valve lever. |
| Vehicles with automatic gearbox |
| –
| Adjust throttle control cable by reconnecting the plug-in catch at support in such a way that the throttle valve is fully opened and the kick-down switch clicks audibly. |
| –
| Release the accelerator pedal or remove the expansion rod. |
| –
| After the setting, check the idle and full throttle stop on the throttle valve. |
|
|
|
